Power Drawbar Frame – add your own Butterfly Impact Wrench

Specifications

This is the frame I use on my power drawbars. It does not come with the required Butterfly Impact Wrench. Many of you who already own a butterfly impact wrench have requested to purchase just the frame, so here it is. The hole for the BIW is 1.26 inches in diameter, this will accommodate all of the BIW's I have come across. Just remove the rubber nose cone on your BIW. There are 4 set screws that hold the BIW in place, and you are good to go.

Related Items

Alloyman 20V Brushless Right Angle Impact Wrench, 207 Ft-lbs（280N.M&#6528

Gorilla Clear Original Gorilla Glue, 3.75oz

Predator Generator gas tank extended run time kit auxiliary fuel tank 9500

3″ x 450′ Reinforced Water Activated WARNING tape heavy duty gummed 10 rolls/ cs

SENIX 20V Max* 1/2” Brushless Impact Wrench PDWX2-M3-0 *TOOL ONLY*

NORWEGIAN AIRFILTERS HV-H13 V-Bank HEPA Filter, 24x24x12, H13 Rating

VEVOR 1 Inch Drive Air Impact Wrench 5175 ft-lbs Pneumatic Tool

Chevron Performance Pipe 4″IPS SDR11.0 Butt 90D ELL Driscoplex